![]() ![]() ![]() If you can find some, then order the board and look for more instructions. Before ordering your board, make sure you can find instructions for that specific board. Its worth it, but it will be very frustrating. It will be a pita, it will take longer than you think, some plugs might be installed backwards. I have replaced my board as well, and a word from the wise: be patient. I know it's my mistake, but Creality really shouldn't be shipping metal clips for this! Any ideas what I should be looking for? I'm leaning towards just replacing the mother board, but I'd like to hear if anyone has any other suggestions? Thanks! I can use Cura to set the bed temp to 137 and above, but this eventually warps my PLA prints because the bed gets so hot! I don't know exactly how hot it actually gets, but I don't believe it's anywhere near 137, or 128 for that matter.Īnyways, I've already opened up the control box and looked at the connections, and taken the mosfet out to inspect it for any damage, but it appears to be fine. After a couple minutes printing, the displayed temp will instantly jump to 137, effectively stopping the bed from heating because it believes it is already above the requested temp. The bed will heat up as long as I set it to 128 or above. It is always 128, whether the hot bed is plugged in or not. The only problem is that now the info screen shows a bed temp of 128c immediately upon powering on, even though the bed is cold. I unplugged the power, and after a few minutes the box was able to start normally. The control box made a loud shrill noise and the screen went all white. On my CR-10 Mini, while experimenting with different positions for the alligator clips that hold the glass to the hot bed, the metal part of one of the clips laid across the connectors that link the hotbed with the wires going into the control box. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |